ST6 Solar steel Ground Mounting is usually applicable to the open filed and ground. It has good strength and can be easy to install for solar panel mounting.
Brand:
UISOLARItem NO.:
ST6Color:
ChinaShipping Port:
XiamenLead Time：
20 days
ST6 Solar steel Ground Mounting
|
Module Angle |
10-60 degrees |
|
Max. Wind Speed |
60m/s |
|
Snow Load |
1.4kN/m2 |
|
Material |
Steel Q235 |
Versatility
Available solar racking use on open filed or mountain.
Cost-effective solution
Highly pre-assembled, save cost and time.
Strength Solution
All design can be strong enough after strength analysis.
Pile Ground Mounting is one of strong structure of UISOLAR. Steel post can easily dig into the earth around 1.4 meter by machine. The Single Ground mounting have highly corrosion resistant as the hot-dip galvanizing average layer thickness is more than 80μm.
UI SOLAR ground ground solar mount usually applicaple to the open field ,not only for residential project ,but also for the big commerial project.
Ground Mounting 90deg Vertical ground The Ground mounting have highly corrosion resitant as the hot dip galvaning average layyer thickness is more than 80um. 1. It can applied to concrte block and piling foundation. 2. Easy to clean solar panels 3. The structure is simple and the bracket is fixed by bolts and pressure blocks.
1. Remove stagnant water automatically 2. Increase power generation to prove the service life of solar panels. 3. Easy installation. Fasten the frame of the solar panel automatically. Suitable for frame thick of solar module: 30 mm, 35 mm, 40 mm 4. Solar Panel Cleaning Clip is a rectangular self-stick polymer strip containing a water-inducing agent. stick to the frame of the photovoltaic module, there is no need to make adjustments to the components. In case of rain, the sludge water collected at the bottom of the frame is automatically directed over the frame and discharged and discharged in the stage of sludge water formation! 5. Through tests, it was found that the water accumulation and dust accumulation along the boundary of the components of the sludge belt was essentially eliminated after the installation of the water guide adhesive, the power generation gain increased from 2% to 10%. 6. Stainless steel material, long service life, no need for frequent replacement.
L feet and hanger bolts are used in tin roof installation. Commonly used hanger bolts are M10*200, M10*250 and M12*300.Of course, customized are available here.
UISOLAR tile roof hooks are used for roman tile roof, flat tile roof, asphalt tile roof and slate tile roof. Material :stainless steel 304 Surface : sandblasted make hooks highly corrosion resistant Accompany accesories components: wooden screws(M6.3*80, Aluminum nut +bolt (M8*25mm allen bolt ) for rail connection
New Aluminum ballast mounting is suitable for flat Concrete roof. Aluminum structure don't need penetrate to the roof, all the solar panel will connect as a whole part and increase the strength. Adjustable bracket range is 10-35 deg.
UISOLAR frameless solar clamps are made of Aluminum 6005-T5 & EPDM and used for the framless solar panel installation. It's approved by First Solar & Canadian Solar & JA Solar. Thin Film Clamps especially for: 1.First Solar series 4 Modules 2.Canadian Solar CS6X-P-FG 3.Trina Solar Duomax TSM-PEG14. 4. JA Solar 5. Other panel with the thickness 4~9mm
The Solar Bird net is designed to keep birds and rodents from getting under solar panels to damage the roof and electrical wiring. This system protects panels by creating a physical barrier that excludes pests from solar panel mounting areas. The system fix to the solar panels without damaging the solar panel or voiding the panel warranty.
UISOLAR solar clamps are made of Aluminum 6005-T5 and can be suitable for the solar panel with the thickness 25~50mm. It can be equipped with different nuts and applicated with different length of bolt to meet different requirement. The color can be both Silver and Black. Grounding pins can be added to the clamps to make it grounding purchase.
To ensure safety, solar project with fence more durable and safer. To prevent accidents, the fence can prevent children entering to causing accidents.
The Floating PV Mounting System is designed for solar installations on water surfaces such as lakes, reservoirs, and ponds. The system adopts durable HDPE floating structures, corrosion-resistant aluminum alloy and Zn-Al-Mg coated steel components, ensuring long-term stability and reliable performance in water environments.
Universe Solar(UISOLAR) is a high-tech enterprise specializing in the development,manufacturing and marketing of PV mounting. With our top quality and service, UISOLAR mountings are welcomed by most of the installers, distributors, and EPC ect. all over the world.
Please read on, stay posted, subscribe, and we welcome you to tell us what you think.
online service
+86 (0592)5663849
sales@uisolar.com
solar-mount.au
English
français
Deutsch
русский
español
português
Nederlands
العربية
日本語
한국의
IPv6 network supported